AV-over-IP platforms let universities send video, audio, and control across the campus network instead of through dedicated matrix switchers and point-to-point cabling. Lecture halls, active learning classrooms, overflow spaces, athletics venues, and campus signage can all share sources and destinations over standard Ethernet.
The right platform depends on how each space uses video, how far the system needs to scale, and how well it fits the network your IT team already runs.
What is the best AV-over-IP platform for a university campus?
The best AV-over-IP platform for a university campus is the one that matches each space’s latency and image quality needs, runs on the campus network’s available bandwidth, interoperates with existing control and audio systems, and can be managed centrally as the deployment grows. Most campuses use more than one approach: low-latency platforms inside teaching spaces and compressed or streaming platforms for building-wide and campus-wide distribution.
How AV-over-IP works
An encoder takes a video source, such as a lecture capture feed or a laptop, and converts it into a network stream. A decoder at any display on the network receives that stream. Network switches handle the routing, so adding a new room means adding endpoints rather than replacing a central switcher. This is what makes AV-over-IP the foundation for scalable audiovisual systems in higher education.
Six decision criteria for AV-over-IP solutions
1. Latency and image quality. Teaching spaces with live presenters, interactive displays, and in-room confidence monitors need very low latency so motion and annotation stay in sync. Overflow rooms, signage, and campus broadcast can work well with higher compression and slightly more latency.
2. Network bandwidth. Some platforms run on 1 Gb Ethernet using visually lossless compression. Others use 10 Gb Ethernet for uncompressed or near-uncompressed video. Match the platform to the switching your campus has in place, or plan network upgrades as part of the project.
3. Scalability. Confirm how many encoders and decoders a platform supports, how multicast is managed, and how the system is organized across buildings. Campus deployments benefit from platforms that support IGMP-based multicast and clear stream naming at scale.
4. Interoperability. Check how the platform connects with your control system, audio DSP, lecture capture, and meeting platforms. Open standards and well-documented APIs make it easier to combine components from several manufacturers.
5. Central management. Look for tools that show every endpoint, push firmware, and flag issues across the campus. This keeps a growing video distribution system manageable for a lean AV and IT team.
6. Audio handling. Video distribution is only half the experience. Confirm how the platform carries audio, whether it supports Dante or AES67, and how it ties into your networked audio visual technology.
Comparing leading AV-over-IP platforms
| Platform | Network | Video approach | Strong fit on campus | Ecosystem notes |
| Crestron DM NVX | 1 GbE | Visually lossless compression, 4K60 | Classrooms, lecture halls, campus-wide distribution | Integrates with Crestron control and cloud device management |
| Q-SYS NV Series | 1 GbE | Compressed 4K video within the Q-SYS platform | Spaces standardized on Q-SYS audio, video, and control | Single software-based ecosystem for audio, video, and control |
| Extron NAV | 1 GbE | Compressed 4K video using Extron’s own codec | Classrooms and venues using Extron control and switching | Pairs with Extron control and management tools |
| SDVoE-based systems | 10 GbE | Uncompressed or near-zero latency video | Simulation labs, medical training, high-detail content | Supported by multiple manufacturers through the SDVoE Alliance |
| Dante AV | 1 GbE | Compressed video with Dante audio and sync | Campuses already standardized on Dante audio | Shares Dante discovery and routing tools |
| NDI | 1 GbE and up | Software-friendly compressed video | Lecture capture, production, streaming | Wide support in production software and cameras |
| IPMX | 1 GbE and up | Open standard built on SMPTE ST 2110 and NMOS | Institutions prioritizing open, vendor-neutral standards | Developed by the Alliance for IP Media Solutions (AIMS) |
Many campuses combine two or more of these AV-over-IP solutions. A common pattern pairs a low-latency platform inside each teaching space with NDI or a streaming platform for capture and campus-wide video distribution.
Planning a campus-wide deployment
- Inventory spaces by use case. Group rooms into types such as active learning, lecture hall, seminar, overflow, and signage, and define video needs for each.
- Assess the network. Review switch capacity, multicast support, PoE budgets, and fibre between buildings with campus IT.
- Choose a primary platform per space type. Match latency, quality, and ecosystem fit to each room standard.
- Design for central management. Define stream naming, VLANs, and monitoring before the first room goes live.
- Pilot, then scale. Build one or two reference rooms, gather faculty feedback, and roll out in phases aligned with the academic calendar.
Frequently asked questions
What is AV-over-IP?
AV-over-IP is a method of sending audio, video, and control signals over a standard Ethernet network using encoders and decoders, replacing dedicated matrix switchers and point-to-point video cabling.
Do AV-over-IP platforms need a separate network?
Not necessarily. Many universities run AV-over-IP on dedicated VLANs within the campus network, with switches configured for multicast. Larger or higher-bandwidth deployments may use dedicated AV switching.
What is the difference between 1 GbE and 10 GbE AV-over-IP?
1 GbE platforms compress video to fit standard network links. 10 GbE platforms carry uncompressed or lightly compressed video for the lowest latency and highest detail, and require 10 Gb switching.
Can different AV-over-IP platforms work together?
Platforms from different manufacturers do not usually exchange video streams directly. Open standards such as IPMX are designed to improve interoperability, and an integrator can bridge systems through gateways and control programming.
How does AV-over-IP support lecture capture?
Encoded video can be routed to capture systems, streaming encoders, and overflow rooms from any point on the network, making it simpler to record and share lectures across campus.
Plan your campus audio visual infrastructure
GAV MGMT designs and builds AV-over-IP systems for higher education, selecting platforms from a multi-vendor portfolio to match each space and the campus network. Book a planning session to map your spaces, review your network, and see AV-over-IP running live at the GAV MGMT Experience Centre in Toronto.
Written by Gianfranco, Digital Marketing Manager at GAV MGMT



